photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Type your message and click Add Comment
It is best to login or register first but you may post as a guest.
Enter an optional name and contact email address. Name
Name Email
help private comment
Kenneth MacDowell | profile | all galleries >> Tech Stuff/Information >> Autococker body Measurements/Specs (Thread and diameter sizes) >> Threads & Holes tree view | thumbnails | slideshow

Threads & Holes

Valve Retaining Jam Nut.........................................5/8"-18 5/16" long hollow lock screw
Valve Guide Screw (located on underside of body) .....5/16"-24 1/4" long set screw
Cocking Rod Knob.................................................5/16" OD 10-32"
All (or most) hammer kits.......................................1/4"-28 x 1/2" setscrew, with the first approx. 3/16" turned down to just narrower than the 'Cocker body slot.
Lug slot under body..............................................3/16"
Bolt o-rings ........................................................0.1" thick, 0.5" ID, 0.7" OD
Banjo bolt Pre2k...................................................3/8-24
Banjo bolt 2k+.....................................................9/16-24
Ball Detent Hole...................................................3/8 -24
IVG (Velocity adjuster)..........................................3/4-16
3-way hole in front block.......................................15/32"-32
Ram hole in front block...........................................6-32
Cocker Barrel Threads...........................................15/16"-20, Oversize GH-7
Autococker LPR Hole on front block.........................1/8" NPT
Pump Arm hole (where ram shaft threads into)..........10-32
2k+ body with rounded bottom all the way to the front
2k+ body with rounded bottom all the way to the front