Valve Retaining Jam Nut.........................................5/8"-18 5/16" long hollow lock screw
Valve Guide Screw (located on underside of body) .....5/16"-24 1/4" long set screw
Cocking Rod Knob.................................................5/16" OD 10-32"
All (or most) hammer kits.......................................1/4"-28 x 1/2" setscrew, with the first approx. 3/16" turned down to just narrower than the 'Cocker body slot.
Lug slot under body..............................................3/16"
Bolt o-rings ........................................................0.1" thick, 0.5" ID, 0.7" OD
Banjo bolt Pre2k...................................................3/8-24
Banjo bolt 2k+.....................................................9/16-24
Ball Detent Hole...................................................3/8 -24
IVG (Velocity adjuster)..........................................3/4-16
3-way hole in front block.......................................15/32"-32
Ram hole in front block...........................................6-32
Cocker Barrel Threads...........................................15/16"-20, Oversize GH-7
Autococker LPR Hole on front block.........................1/8" NPT
Pump Arm hole (where ram shaft threads into)..........10-32