Type your message and click Add Comment
It is best to
login
or
register
first but you may post as a guest.
Enter an optional name and contact email address.
Name
Name
Email
help
private comment
Kenneth MacDowell |
profile
|
all galleries
>>
Tech Stuff/Information
>> Autococker body Measurements/Specs (Thread and diameter sizes)
tree view
| thumbnails |
slideshow
Autococker body Measurements/Specs (Thread and diameter sizes)
-JAM NUT (valve retaining nut)----------------------- 5/8"-18 5/16"
-VALVE GUIDE SCREW (under body) ------------ 5/16"-24 1/4"
-COCKING ROD KNOB--------------------------- 5/16" OD 10-32 stainless threaded standoff, 3/4" long
-All (or most) newer HAMMER KITS------------ 1/4"-28 x 1/2" setscrew, with the first approx. 3/16" turned down to just narrower than the 'Cocker body slot. (Itself 3/16".)
-IVG (internal velocity adjuster)----------- 3/4-16
VERTICAL ASA SCREW ------------------------- 1/4-28 (12 point head)
Bolt o-rings ------------------------------- 0.1" thick, 0.5" ID, 0.7" OD
-BANJO BOLT (front block screw)
Pre2k -------------------------------------- 3/8-24
2K+----------------------------------------- 9/16-24
-BALL DETENT-------------------------------- 3/8 -24
-3-WAY-------------------------------------- 15/32"-32
-RAM SHAFT---------------------------------- 6-32
-FRONT BLOCK RAM HOLE----------------------- 5/16-24
-BARREL THREADS----------------------------- 15/16"-20, Oversize GH-7
Autococker LPR ----------------------------- 1/8" NPT
Pump arm ----------------------------------- 10-32
98 STO broken down to rebuild
comment
|
share
Type your message and click Add Comment
It is best to
login
or
register
first but you may post as a guest.
Enter an optional name and contact email address.
Name
Name
Email
help
private comment
Type your message and click Add Comment
It is best to
login
or
register
first but you may post as a guest.
Enter an optional name and contact email address.
Name
Name
Email
help
private comment
click on thumbnails for full image
