How To MAKE and Install a Countertop End Cap - YouTube

See This Report about How to Cut Laminate Countertops » The DIY Hammer

Drill a starter hole inside the design template marks. The bit ought to be broader than the blade to your jigsaw. Screw a 12 (you can use the exact same piece you used for a rip fence if it is larger than the sink) to the center of your future hole. This will support the cut away so that its weight won't break any laminate when reaching the end of your cut.

Place the blade into your starter hole and begin cutting. Once again, constantly have the blade as much as full speed before starting the cut. You will find that it is a little harder to manage a straight line with a jig saw but not to stress, the lip of the sink will cover any minor slips over your mark.

Post-formed countertop (the kind with the integral backsplash and drip edge) is quick and easy to install-- as long as you do not have to cut it. Then it's awkward to deal with, the backsplash needs a different cut, and the plastic laminate chips easily. Industrial fabricators utilize large fixed saws with 12"- or 14"- dia.

Few people have that type of equipment, but you can get accurate outcomes with a circular saw and a shop-built jig. The jig simulates the easy guide a great deal of people use to cut plywood, however it has a 2nd (much shorter) leg that wraps around the backsplash. I built my jig out of scrap 3/4" plywood and used some remaining 1/2"- thick crave the cleats that assist the saw.

How To Cut Laminate Sheets With A Table Saw

Facts About How to Cut Laminate Countertops » The DIY Hammer Revealed

Then install the cleat on the short leg of the jig and trim that side of the jig also. Because the edge of the jig is now completely lined up with the saw's blade, you position this edge on the countertop right on the line where you desire to make your cut.

Before making the backsplash cut, I set the countertop on sawhorses so it rests on the backsplash. Full Article lets me make an almost horizontal cut rather than trying to hold the saw vertically. (KEEP IN MIND: When cutting counter top, use a fine-toothed plywood cutting blade to lessen breaking in the plastic laminate.) When you have actually got the backsplash cut, set the counter top on sawhorses and cut the large section.