photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Topics >> by >> plumbing_like_a_pro_tips_t

plumbing_like_a_pro_tips_t Photos
Topic maintained by (see all topics)

Content written by-Raymond Ferguson

Professional plumbing is often a very expensive service, and usually the work that is done is something that any homeowner could solve fairly easily with the proper knowledge and tools. If you'd like to start learning to solve your own plumbing problems, read on to see what you can do.

You can check your toilet for leaks by adding a few drops of food coloring, Kool Aid or some coffee grounds to the water in the toilet's tank (not the water in the bowl). Check the water in the bowl after a half hour or so. If any of the coloring agent is visible in the water in the bowl, the tank is leaking, and you will have to have it repaired.

Avoid using hard cleaners on your toilets, such as drop-in cleaner tabs in the tank. When these tabs are almost completely dissolved, what's left of the tab gets washed into the bowl. This can then end up clogging the toilet's port holes, preventing the toilet from flushing properly. It can take months for this debris to finish dissolving in those holes.





Stay away from bleach tablets, blue tablets for the toilet and other toilet odor removers. These products can be great when it comes to getting rid of odors, but unfortunately, they can cause significant damage to the rubber portions of your toilet. This can lead to it breaking down or having other issues.

Be careful about using liquid clog cleaners. These liquids can contain chemicals that are extremely bad for your pipes. Instead, use a snake or a plunger to dislodge any clogs you might encounter. Be sure to try these things before giving up and calling a plumber, who will probably re-perform those same acts.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out browse this site damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Do not forget to check the temperature of the water heater in your house, especially if you are planning to leave for an extended period of time. You should keep the temperature no higher than 120 degrees, which will help to reduce energy use and prevent your system from burning out.

If your home has well water and you start seeing orange or pink stains, that is from iron in your water supply. Using a water softener can help fix this problem. You can obtain a water softener at any home improvement store, or rent them from specialist companies.

You have to always be aware of where the primary water shut off valve is in your home. You should see a water meter located on it or close by. Fixtures, such as sinks or toilets, may also be equipped with individual cut-off valves. Make sure every member of the family knows where the values are located, and mark them so they are easy to turn off in case the need arises.

You can research a plumber online, even if you did not choose them. You can use customer feedback to prepare for the plumber that the insurance company has assigned you.

When plunging a drain to attempt to remove a blockage, first make sure that the drain is completely covered in water. This helps to form a seal. Then, plunge at least fifteen to twenty times before stopping. Repeat the process two to three times. If this doesn't work, try a chemical drain cleaner.

To lessen the amount of hair going into your home plumbing, thoroughly brush hair and use a body brush to remove loose body hair before entering the shower or bath. If it's been a while since you have shaved your legs or face, use an electric razor to remove the longer hair, before shaving in the sink or shower.

It is important to clean your faucet's aerator from time to time. Not cleaning it can cause lime buildup, which in turn, could cause water leaks or low water pressure. To clean a aerator, you can unscrew it from the faucet, dip a brush into vinegar, and use the brush to clean it.

Tank-less water heaters are a great space saving alternative to traditional tank units. They are available in many models, some for indoors and some models are capable for outdoor mounting. Tank-less water heaters are known as great money savers when it comes to your water bill.

The most common cause of leakage with compression faucets is the washer. If you have a leak, unscrew the handle and remove the escutcheon with a screwdriver. Pull the stem and see if the washer is still intact. If it isn't, you know where your problem is.

Tankless water heaters can be a great alternative if you want to save money and resources. These heaters only heat water when it is needed, so they do not store any water the way a regular heater does. A number of dollars are saved off of power bills because unused water is not heated just to sit around.

Coat your sinks with expanding foam to deaden sounds. If you have to sinks side by side, sounds will resonate strongly between them and create vibrations. This is not good for the pipes. The expanding foam will reduce the vibrations and protect your pipes. You might find it easier to apply foam before you install the sink.

Make sure that you avoid throwing fats down the drain after you clean up your meal. Fats can solidify over time which can cause a drainage problem and corrupt your water flow. Throw out fats and different types of cooking oils in the garbage after you finish with your meal.

If http://dailyinsidescoop.com/news/happy-customer-gives-midwest-plumbing-indianapolis-a-grateful-five-star-review-detailing-the-experience/0279285/ are seeing areas in your ceiling or walls that appear to have water damage or are sagging, make sure you turn off the power before inspecting. Electricity and water do not mix. The last thing you need is to go into the attic and get shocked by a pool of water.

In conclusion, you want to be sure that you are getting the best information for someone who knows at least a bit about plumbing. Hopefully this article was perfect for you and you learned at least something. Do not hesitate to keep on furthering your knowledge to give you an even better background.









has not yet selected any galleries for this topic.