Foreword
When the capacity of the processing system generated by the programming software is larger than the capacity in the memory from the CNC technique, the transmission process of the processing program cannot be used. In http://www.yahoo.com , the larger processing program is usually placed within the memory card, plus the machine tool can be run within the CF card just after setting. Processing how to recover ntfs partition without losing data , which solves the problem of insufficient CNC storage capacity during processing.

Nowadays I will introduce you to the use of memory card processing procedures, DNC setting system:



CF card DNC processing setting steps
1IO channel is set to: 4 (memory card)
Parameter setting: 138#7=1

two Open the [Remote Control] approach:

3【Program】-【Directory】-【Device selection】
--【M Card DNC】

4 If the plan file is just not displayed, press [Update]
Choose the plan to be processed and press【DNC setting】

5After setting, the letter [D] will seem in the starting of your plan

6 Press the cycle start off button around the operation panel in the machine tool to execute DNC machining

note:
Before beginning, confirm that the plan is right, the tool and tool parameters are right, as well as the workpiece and workpiece coordinates are appropriate, then set the 'Feed override' to zero position, single block mode, press [Start button], the CNC machine tool will jump towards the set program Execute DNC processing.
7 Cancel [DNC] on the web processing steps and switch back towards the machine tool [CNCMEM] as follows:


Related Links:
Ways to use FANUC plan transmission tool



related software program: