Today we are going to change the fog light bulb in the VW Jetta to H11 led bulb. We're gon na start by getting rid of 4 25 bolts here and at the end do you get the front bumper off. Start by removing these t25 bolts from the bottom and necks activate to move the t25 bolts that lie inside the fender well. We're gon na do the exact same on the other side of the automobile. If you need to take off your front bumper, there is a guide along the back of this bumper. So you're gon na wish to use some pressure forward to get out of the guide and after that it's all going to come right out to finish removing the front bumper.


If your car is geared up with fog lights, you wish to get this just twist and pop it out and do the same on the other side. There are two t25 screws, just eliminate them on the bottom of your foglight, you will find the adjuster. As there is a hole in the front of the bumper, put a socket through and adjuster headlight to aim for the road to put the fog light back into the bumper.

We're going to take your fog light with the adjuster down, these 2 alignment female slots on the bumper, hold it in location, get your t25 bolt to put the bumper back in.

When your bumper is still lightly connected by the center and the side is still disconnected, you're gon na take your fog light bulb, location it in and twist it back into its lock position. Do the very same for the opposite, to put the bumper back onto the brackets which have clips the whole time the top, make it sure it's lined up below the headlight. Press it back into location to reinstall the hardware into the bumper, the liner in fact attaches to the other screws that go into the bumper to attach the liner back to the bumper.

Take a look at our site if your interested: https://cambyocar.com/ for additional information.
That you're gon na wish to get prior to the skirt and then to put the liner back in. You're gon na want to fold this over and after that put your 3t 25 volts back into place, if you reconnect the shield back up to the car. You're beginning with one side back into location and the last action you want to take the rest of your t25 bolts and line up your grill on the top and screw it down it must be all set.