Today we are going to replace a fog light lens on 2011 Chevy Camaro. Tools you require are interior trim elimination tool package, T20 torx socket, flathead screwdriver, Phillips head screwdriver, replacement 9005 led bulbs.

You just need to turn the wheel to the right, so you can access the three Torx bolts. That is right on the inner fender liner, there are t20 bolts and you'll want to remove those in addition to the two clips on the top of the fender liner. You can press the liner out of the way with the tool, you can pop it right in the clip and pull the clip right out of the fender liners. As soon as you have the center's out the bottom half will come out really easily, there's one more clip right here in the back on the inner wheel well. We'll pop out the center and after that the bottom half and the fender liner ought to be loose at that point.

The initial step in changing the fog light is removing the bezel simply on the outside of it. Launch the clips, there's five of them around the outdoors housing and you just generally take a small flat suggestion screwdriver. You can pry in the little plastic tabs and pull them out and then you can lower on the bezel. And the bezel clips will pop right out, once they're released, you must have the ability to pull the bezel right out of the bumper. The fog light is kept in with three push pins, every one has a couple of tabs on it. Pop them out of the housing or a ten millimeter socket works pretty well just sliding it over there and releasing the clips. And after that go to the next one and release those clips, you'll wish to pull the connector out, the fog light can pop right out.
By study on https://www.catherinefergusonacademy.org/, you will be able to repair your car by yourself.

The lenses look quite identical and the mounting on the back is the same also. Then connector very same pushpins and it need to snap right in and fit just like the original windows. You'll simply move it right into the 3 holes that snaps into and if you simply press it right into location the clips will lock in. And the fog light will be mounted to the bumper. The bezel you're going to put the big side to the inside edge of the bumper and it simply presses right into place. It has a couple of snaps have 5 snaps around the outside edge that you'll wish to double check that they click on on the behind of the bumper. And as soon as they snap in its installed lasting the hookup, the connector which again it simply presses right into place.

A long stud that's on the fog light really has a Phillips head screw on the within it. So all you do to change it is put a full tube screwdriver in it and turn it and it will change it on the bumper side. The fender liner can now be back into place tuck it behind the ABS sensing unit wire and then begin putting your pushpins right back into location. You'll wish to reinstall your three t20Torx screws next in the front of the fender liner.