The Of Formica Countertops - B&T Kitchens & Baths

Cut these strips with the keep piece off the lumber. Job the cutline inch past the edge (to represent the router bit's width). When using a router, cut from delegated right as you deal with the edge (and the tool is upright), to keep the bit from pulling. Adhere the side pieces Utilizing a chip brush, use contact cement to the back of the laminate strips for the counter's brief sides and onto the substrate sides.

Allow the contact cement on both parts to dry to the touch. Take a strip and position it over the side without letting it touch, making sure it's equally aligned all around. Working from Related Source Here to the other, stick the laminate to the substrate, smoothing it as you go.

Retouch unequal edges Utilizing the router turned on its side, cut off the overhanging edges of laminate, running the bit counterclockwise around the edges. Retouch irregular edges with a file or sander, keeping it flat on top of the particleboard and pressing far from the laminate. With the sides done, glue and trim the front edge.

Laminate countertops love undermount sinks

Keep the bit devoid of adhesive by occasionally unplugging the router and soaking the bit in water. Cover laminate back and substrate with contact cement Turn the top laminate sheet facedown. Pour contact cement onto the back and, using a paint roller, spread the adhesive over the entire sheet. Roll any excess onto the substrate.

How Four reasons to love your laminate countertops can Save You Time, Stress, and Money.

Enable the contact cement to dry to the discuss both parts. Laminate the top Lay wood scraps or dowels throughout the substrate every 12 inches or so. Turn the laminate so that it is adhesive-side down, and rest the sheet on top of the scraps without allowing it to touch the substrate.

How to Paint Laminate Countertops - HGTV

Laminate Kitchen Countertop - HGTV

Starting in the middle, get rid of a scrap and press the laminate down. Working out from the center, continue eliminating scraps and pushing the sheet into place, till the whole sheet is adhered. Roll over the counter with the J-roller, utilizing firm strokes. Using the trim router, cut off the excess around the perimeter.