Authored by-Koefoed Iversen

Were you aware that water pressure above 80 psi can actually cause a loud hammering sound to occur in your plumbing system? This can be easily resolved by installing a valve that can adjust the incoming water pressure. For more great expert tips, check out the rest of this article.

Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.

Make sure you know where your home's water shutoff is located. You never know when there might be an emergency involving a broken pipe or damaged connection that requires you to turn off the water right away. In addition, knowing where the shutoff is located is vital before you start any plumbing project, in case anything goes wrong.





Check your faucets for leaks. Check the knobs and the faucet itself. Hundreds of gallons of water a day can be wasted due to leaks and that's not good if you're paying your water bill. By stopping a leak now, you can save yourself a lot of money. Leaks can grow over time as well, so avoid a disaster and check all faucets for leaks!

Frozen and bursting pipes from harsh winter weather is a problem that no-one wants, so plan now to winterize your exterior faucets and pipes against freezing conditions. A simple way to accomplish this is to find the exterior water shut-off valve located inside your home (often located in the basement). Turn off the water valve to stop water flow, and then open up the outside faucets to drain out any water that has collected. Be sure to turn off the outside water faucets tightly after the water has drained out. Take in Storm Drain Cleaning Near Me may have outside so they don't crack from the cold weather.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

It is not always necessary to call in a plumber when you have a damaged section of pipe in your plumbing. There are repair kits you can buy in your local hardware store which are excellent in repairing leaks. If you have a small leak, you can rub a compound stick over the hole or crack in the pipe to seal it shut. Epoxy paste is also an excellent remedy for a leaking pipes. Make sure you turn off the water and completely dry the pipe before applying the epoxy.

Unclog drains with ease. Try using a plunger and drain cleaner, as your clog may simply be a build-up of hair and debris. If this doesn't work you may have to clear the drain with a snake. Feed the snake into the drain line as far as it will go. Turn the crank gently, which will help to loosen the clog. Remove the snake, and run water down the drain to see if the clog has been removed. You may have to use the snake a couple of times, before the clog is cleared so don't give up!

Before embarking on a plumbing project, make sure that you're aware of where the shutoff valve for water in your home is, as well as the valves for shutting off individual structures like sinks, toilets, etc. This way, if something goes wrong, you'll be able to stop the water flow.

Believe it or not, it is not a very good idea to use a plunger if your toilet is clogged. Plungers just push whatever is stuck deeper into the drain. Instead, it is a better idea to use a closet auger. It will do a better job and is affordable.

Everyone in your home should know where the main water shut off valve is. By knowing where to find this valve, you'll be able to shut off the water in the event a pipe bursts, a bathtub or toilet overflows or any other emergency that requires you to turn off the water.

visit this link to save a few dollars is to add insulation to your hot water heater. Much of the energy required to heat the water in your home is the expense from keeping the water in the tank hot for when it is needed. Adding an extra layer of insulation can help reduce this cost.

During the winter months, your water heater works the hardest. To keep it in optimum condition, flush it out before winter arrives. Flushing the system helps remove the sediment buildup, which causes internal corrosion of your water heater, shortens its lifespan, and reduces heating efficiency. Connect a hose to the faucet near the bottom of the tank and drain several gallons by directing the water into a nearby drain.

If you have an ice maker or other plumbing going to your refrigerator, every six months or so pull the refrigerator away from the wall and inspect this plumbing. There should be no condensation or corrosion on these plumbing lines, if there is, contact a plumber and have them look at it.

To check for toilet leaks, especially if it seems like your toilet is chronically running, use a few drops of food coloring in the toilet tank. If water is leaking into the bowl, you will see color in about a half hour. Replacing tank parts can repair leaks and greatly save on water consumption.

You should consider getting a stainless steel sink if you are in need of a new sink. Stainless steel sinks are much better than other ones for many reasons. They are more durable, they absorb shock, they are easier to clean, and they go with almost any decor.

Keep a grease vat in your kitchen to pour all used cooking grease into. Grease is a big reason that kitchen drains slow and eventually, stop up. Even the harshest drain cleaning products, tend to not be a match for a heavy grease clog. The grease you save in the vat can be formed into balls and rolled in bird seed for wonderful winter bird feeders.

If your lawn has areas where the grass grows very quickly compared to the rest, seems constantly wet or has a noxious odor you may have a sewer line leak. A leak or crack in sewage pipes can be repaired if caught early and save thousands of dollars in failed septic inspection expenses.

To prepare for the cold weather, properly drain all outside faucet bibs and turn off the water supply to those faucets. A piece of foam taped to the outside bib can provide excellent insulation to prevent any remaining water from freezing or splurge for a specialty cover that comes complete with velcro closures.

If your water bill seems unusually high and you haven't changed your water usage, the problem is most likely in the service line. The cost to hire a professional to find and repair the service line most often is far greater than installing a new line and then having the old one shut off permanently.

Plumbing can be an advanced, highly technical profession where more often than not, you need an experts help. However, sometimes that is not the case and there are some simple do it yourself home fixes. If you take a little time to read about them you will find some of the most common plumbing problems are able to be handled by the common man.