|
|
|
|
|
|
|
| thealbert | profile | all galleries >> Cars >> E30 325is >> transmission_swap | tree view | thumbnails | slideshow |
 DSCN2387.jpg |
 DSCN2388.jpg |
 70 Alignment problem if we use the wrong center bearing housing.JPG |
 69 MT center bearing housing too small.JPG |
 67 Connecting propeller shaft to center bearing.JPG |
 66 Rheynan installing propeller shaft.JPG |
 65 Shifter link installed.JPG |
 64 Shifter installed.JPG |
 63 Shifter plate installed.JPG |
 62 Starter installed.JPG |
 61 trial fitting starter from MT.JPG |
 60 starter motor location in bellhousing.JPG |
 59 Connecting line from clutch master to brake fluid reservoir.JPG |
 58 MT installed.JPG |
 57 Secondary clutch cylinder installed.JPG |
 55 Aligning the tranny with the engine.JPG |
 54 Connecting tranny to clutch set_bellhousing.JPG |
 53 Clutch set all done.JPG |
 51 Install release bearing.JPG |
 50 Tightening clutch cover bolt.JPG |
 49 Installing clutch cover.JPG |
 48 Installing new clutch disc.JPG |
 47 New pilot bearing installed.JPG |
 44 MT pedal box installed.JPG |
 43 Getrag 260 - check.JPG |
 42 Edu removing the AT.JPG |
 41 AT pedal box.JPG |
 40 Cleaning the MT housing.JPG |
 39 dirty MT.JPG |
 37 old vs new clutch master cylinder.JPG |
 36 Old clutch master.JPG |
 35 Old secondary clutch cylinder.JPG |
 35 M3 flywheel installed.JPG |
 34 Old release fork and release bearing.JPG |
 30 Old clutch components.JPG |
 DSCN0611.jpg |
 18 Release fork.JPG |
 529425_301262833280090_203274023078972_744737_902122969_n.jpg |
 19 Pedal box.JPG |
 17 Clutch master.JPG |
 16 Clutch secondary slave master.JPG |
 18 Release fork.JPG |
 15 MT clutch cover.JPG |
 14 MT clutch components.JPG |
 2 Exploded view of AT.JPG |
 10 AT shifter being removed.JPG |
 9 AT shifter being removed.JPG |
 8 Exhaust system.JPG |
 7 Underchassis.JPG |
 5 Making sure all bolts are accounted for.JPG |
 6 Transmission tunnel.JPG |
 3 Engine side with AT removed.JPG |
 4 Engine side with AT removed.JPG |
 1 Components of MT.JPG |