|
|
|
|
|
|
|
| Mark Lerman | profile | all galleries >> 2014 Modification of the Lexmark E260 for Direct Laser Printing >> 2010 version with a lot of good pictures | tree view | thumbnails | slideshow |
| previous page | pages 1 2 3 4 5 6 ALL | next page |
 Lexmark E260dn.jpg |
 Controller Board.jpg |
 Transfer Roller Connector.jpg |
 HV Power Supply Removal.jpg |
 Transfer Roller.jpg |
 Transfer Roller Spring.jpg |
 Fuser and Back Stuff Removed.jpg |
 Fuser Link.jpg |
 Paper Feed Solenoid.jpg |
 Paper Feed Mechanism.jpg |
 paper Feed Removal.jpg |
 Toner Patch Sensor.jpg |
 Toner Patch Sensor 2.jpg |
 Toner Patch Sensor 3.jpg |
 Sensor.jpg |
 Front Paper Guide.jpg |
 Manual Paper Feed Platform.jpg |
 Stripped Front View.jpg |
 Left side Paper Platform.jpg |
 Right side paper Platform.jpg |
 Vent Guide Mounting Screw.jpg |
 Ready To Mask.jpg |
 Ready to Cut.jpg |
 Wires Loose For Cutting.jpg |
 Dremel Router.jpg |
 Fingered Paper Handler.jpg |
 Cutting 1.jpg |
 Cutting 2.jpg |
 Cutting 3.jpg |
 Cutting 4.jpg |
 Cutting 5.jpg |
 Bottom View After Cut.jpg |
 Rear Mechanism.jpg |
 Rear View Done.jpg |
 Slot Above shaft.jpg |
 Shaft In Place.jpg |
 Roller Detail.jpg |
 Springs.jpg |
 Springs Installed.jpg |
 Spring Details.jpg |
 Ruler in pcb path.jpg |
 board guide in place.jpg |
 MCU board.jpg |
 2.4K resistor replaces thermistor.jpg |
 Wires to MCU.jpg |
 MCU mounted on door.jpg |
 Clipboard pcb catcher.jpg |
 coated aluminum carrier.jpg |
 Kapton tape on leading edge.jpg |
 pcb on carrier.jpg |
 KY on pcb.jpg |
 ready to print.jpg |
 Out of the back.jpg |
 Perfect first run.jpg |
 Reflective Sensor.jpg |
 Sensor Mounting Hole.jpg |
 Mounted Sensor.jpg |
 5 VDC Connections.jpg |
 New MCU Board.jpg |
 First Registration Attempt.jpg |
 Carrier with Sensing Marks.jpg |
| previous page | pages 1 2 3 4 5 6 ALL | next page |
| comment | share |