Necklace pattern 'Sandy' tutorial/designer ZviaGil Designs

CAREFUL when following pattern, when starting it shows to go into the 2 size 8 beads, that is not right.
Go thru the Fire Polish so the fire polish bead is centered over the Czechmate tile as shown on the front picture of pattern.
If you look closely the start (right side) shows the size 8s are over the CM beads but then CHANGES at where the 2nd Silky beads start to be added (see pix step 19 and 20) & continues all the way to the clasp that way. So the 'ends' are not the same, one end has FP centered over CM the other end shows the 8/0 beads centered over the CM.
Photos & directions clearly show go into the 2 8/0 beads...but changes in photo # that is not how the pix of the finish necklace looks except on the the right side. Was too far along to rip out and do it correctly. SEE other notes by beads used for a different look as far as the DuoDrop, some may want the tip of DD to lie over the tip of the Silky, some may want to have it lie flat.

Materials used:
Seed Beads: 8/0 Toho T288 Met. Blue lined crystal
8/0 Toho T995 Gold lined aqua AB
11/0 Miyuki 4478 blue turq Duracoat (Toho might work better to allow the black DropDuos to lie flat instead of resting on top the Silky bead tip or us 3 Miyuki)
15/0 Toho t-90/c Metallic Amethyst Gun Metal

Fire Polish -4mm grey snakeskin
Silky -Crystal Bronze Fire Red
CzechMate Tiles - Turquoise Moon Dust (grey)
Miyuki Half Tila - TLH1865 - Grey Luster
Czech DropDuo - Jet (black) & Aluminum Silver
Par Puca Amos - Jet (black)


Copper clasp
FireLine 6 & 8 lb.