This shot shows how I rolled the tube over to be able to get the tube low as possible without sitting on the tub floor. Figuring out the angles to notch the tubes was a whole different story! But if you look closely you can see my "slight" problem. On both floor mounting plates for the A and B pillars my tube now slightly covers one of the mounting bolts on each plate.

Before I tacked these in place I needed to do two things, I need to weld the A and B pillar tubes complete under the area where these tubes will sit and I need to figure out how I am going to get the bolt out of the plate one the tube is welded in place. The welding part is the easy part!