|
|
|
|
|
|
|
| fred harmon | profile | all galleries >> concours14 >> turnsignalupgrade | tree view | thumbnails | slideshow |
 Lockhart Phillips light taken apart |
 Wires replaced with thinner computer ribbon cable wires |
 Removing threaded stud from light |
 I used 3M doublesided adhesive to mount them |
 Routing wire behind gasket for lid |
 Wire is stretched tight routed and lightly glued to inside edge of saddlebag |
 Wire goes through hinge at bottom and up inside edg of inner bag half (Left Bag shown) |
 Wires then carefully routed through crevice in latch |
 Wires then carefully routed through crevice in latch |
 Wires exit out back side of latch |
 Miniture Molex connectors used with locks on the connector removed |
 Mini Molex connector halves |
 Wire Routing Finished |
 Completed install |
 Side Emitting LED strip from www.oznium.com |