Towed/Toad project

Roadmaster Falcon2, baseplates, Demco Stay-in-play, accessory kit	Floor heater deflector	Floor heater deflector
Floor heater deflector	Floor heater deflector	Mounting bracket for Demco control unit
Mounting bracket for Demco control unit	Demco control unit next to passenger footwell	Demco control unit next to passenger footwell
Support for Demco "operating unit" vac/pressure pumps	Support for Demco "operating unit"	Operating unit mounted
Operating unit installed	Elec, hose details. Nice fit in inner fender well	Operating unit mounting details
Operating unit mounting details	Routing	Routing
Installing Roadmaster baseplates	Installing Roadmaster baseplates	Installing Roadmaster baseplates
Installing Roadmaster baseplates	Installing Roadmaster baseplates	Initial test fitting
6K tow bar	Installing Roadmaster baseplates	Tail/brake light diode wiring
Motorhome charge line - found stubbed in wire loom	MH Wiring through circular passage	MH-Toad lighting tests
MH-Toad lighting tests	MH-Toad lighting tests	Charge line details - reappropriated Arctic pac line/relay (Large red wire, upper right)
All hooked up!	Turning tests - cannot drive wheel locked in 360 deg circle	Toad umbilical & breakaway location
Toad umbilical & breakaway location - Breakaway stored in non-tow position	Charge/brake system fuses	Firewall passages for air hose, electricals
Firewall passages from driver footwell	Brake pedal air cylinder	Brake pedal air cylinder
Brake pedal air cylinder	reducing the rattle & slop	hitch clamp to stop the movement
shims to reduce the slop	shims to reduce the slop	Crossbar
Washers to reduce the slop; cable tie to keep the kids from removing the pin	Let's go!	Ready to roll
A lot of toad for the MH, but it worked well