Since the passenger seat of a 1970 factory 914-6 car does NOT move to adjust https://pbase.com/image/89739048, I had to find a pair of the rear seat hinges to weld to the newly fabricated Rally Seat Brackets and proceed to install my second Scheel seat.

After searching for a good usable pair of these hinges https://pbase.com/9146gt/image/87505794 and obtaining no less than 10 used samples from several sources around the country, I did finally find 2 used 'still questionable' hinges https://pbase.com/9146gt/image/89737524 that I could try and salvage and use for the passenger side Rally Seat Brackets. The rest of the hinges were too badly rusted, melted and or bent. All steel dowel pins https://pbase.com/9146gt/image/89737528 were found to be too corroded to re-use once removed. We gave them a light media blast and reinspected them but there was too much 'play' at the hinge, about .002" to .003" thousands of dowel-pin material was lost, too bad. The factory hinges are no longer available, but reproductions are still available from Stoddard in Ohio (not the same but close enough for someone not interested in authenticity).

By the way, if you have a pair of 'new' (NOS) rear seat hinges that you can sell me, I would really appreciate it. I actually have four NOS hinges that I missplaced and can't find.