Today we have a 2015 Nissan Altima that we're going to be setting up LED headlights on. This setup is suitable with models 2013 up. That's the fifth generation Altima. And is just compatible with designs that have the halogen headlight so if you have actually HID headlights already you can not convert to LED. Only halogen to LED. Today in specific, we're going to be getting rid of the wheel to get access to the headlights. You do not really need to eliminate the wheel if you're doing the setup at home. You need to have a tool that comes in your trunk to remove the lug nuts.
Regard to auto tips, you could learn on the relevant article source.

There is a fender liner here, it's really avoiding access to the headlight assembly. We're going to be utilizing a flathead screwdriver and a Phillips head screwdriver to eliminate the bolts that are holding it in location. Remove fender liner with a Phillips head screwdriver in addition to a flathead screwdriver. There are three clips.


Release the middle part from the remainder of the clip and pry it back, develop separation between the two pieces, and when you have that separation, you can pull it out.

There are 3 bolts and a clips that need to remove in the wheel well panel. When you have them all out, there is a hole that can utilize to pull down. And produce some separation with the fender

Taking a look at the headlight assembly from the rear right, turn the bulb counterclockwise and that releases the bulb.

When have it out, pull up on this tab, it needs to launch.

Connect the power cables together when you have a center cap, that helps develop a waterproof seal. Turn the bulb clockwise which locks into location. Link the power cable television from the lorry and plug with the H11 LED bulbs.

Putting the ballast with double-sided sticky tape on aluminum assistance on the Altima.

Now that this is all in. We're going to go on and evaluate the lights prior to we put whatever back together.

I've got our thunder liner back, the clip needs to go onto the piece of metal. Make certain that all of this is on the interior of the fender wall not sitting outside. Make certain you're all the way from the outside there you go now that plastic is sitting on top of the metal. Install the three clips on it. As soon as that have done, put the wheel back on if you took it off. The process is the same on the guest side.

And that's completion of the setup.