photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Compass Marine How To | all galleries >> Welcome To >> ***Buy Bed-It Butyl Tape*** > Bed-It Tape
previous | next

Bed-It Tape


Bed-It Tape is specifically formulated and extruded for the installation of deck fittings to the decks of boats. All aspects of the installation procedure and necessary formulation requirements have been brought together in a marine specific bedding tape.

It has been designed to:

*Work across wide temperature ranges with minimal "creep" or cold flow even in hot climates

*Formulated to have exceptional tolerance to withstand slight movement between deck and fitting

*Stand up to typical boat washing chemicals

*Stick to the parts not your fingers

*Have the proper density for use in a "compression" application.

*Have right density to allow it to displace from under the fitting in a reasonable time frame

Bed-It Tape is made only from the finest materials and has been designed to exceed the quality of pre EPA tapes that have lasted for 30+ years..

Bed-It Tape is not an RV, Masonsry, HVAC or glazing product it was specifically formulated for use in bedding deck hardware.

Bed-It Tape is made in the USA with US labor and creates US jobs!!

other sizes: small medium large auto
Phil 17-Mar-2018 00:53
How well does this tape hold up on sides or vertical surfaces? Does it melt or tend to run in hot climates like FL and AZ? If used on a vertical surface to seal a drip rail with a black cover, will it eventually run like Kool Putty does? Thanks!
sailersteve 26-Aug-2014 19:06
YEP it happens . I had the same problem & i found the lowest spot on the rail & drilled a 1/8" hole . It's just enough to let out any water & not harm its strength. It's work for me so far BUT THATS JUST MY EXPERIENCE ?